Main Action Mode.

After configuring ESPrtk, the changed data will be stored in ESPrtk's FLASH memory and they will not be lost during power outages.

Once in Main Action mode, ESPrtk reads the boot instructions and performs the main activities planned in advance by the user (via UART Configure or WEB Configure).

Start Main Action mode.

By default, ESPrtk after supplying power (or RESET ) will enter Main Action mode.

Use ESPrtk command to start Main Action mode

 

Use ESPrtk command control
Step 0	ESPrtk after supplying power.
Step 2	HOST send command : $ESP_OK|5|X|_||*5309
Done	ESPrtk will start go to Main Action mode.
Success	The CONNECT_LED blink slow. ESPrtk respond on TX_UART0: $ESP_OK|5|X|_||*5309

Use the RESET button to start Main Action mode

 

Method 2: Use only the CWB button
Step 0	ESPrtk after supplying power.
Done	Press RESET button (set EN pin to Low level) , then release. → ESPrtk will start go to Main Action mode.
Success	The CONNECT_LED will light continuously . ESPrtk respond on TX_UART0: $ESP_OK|5|X|_||*5309